Ideal low resistance expansion joint filler for brickwork and concrete blockwork
Brickfill fully meets the British Standards for movement joints in brickwork
All pre-cut rolls have a scored tear off strip. Simply build in Brickfill flush with the surface of the brickwork and then pull off the “tear off†strip, leaving a correctly sized recess, to allow the installation of a suitable high performance silicon sealant, without the need for a bond breaker
Sovereign CDM8 membrane provides a robust drainage membrane suitable for above and below ground applications to walls and floors as part of the SovDrain waterproofing system. With a fast track application, the membrane protects new finishes from the effects of dampness and/or salt contamination in above ground situations, and prevents water ingress below ground in areas such as cellars, basements, vaults, and tunnels. This membrane has a relatively low stud profile (8mm), thus minimising wall and floor level changes. The CDM8 membrane is typically finished with either a pre-treated timber stud partition wall and plasterboard or independent stud metal frame system. The floors can be finished with a Sovereign SBR modified screed (minimum 65mm) or a floating floor.
H+H's Celcon Blocks High Strength Grade (7.3N/mm2 identified with a black stripe on the block) is ideal where higher compressive strengths are required such as in the foundations and lower storeys of three storey buildings, piers under high vertical loads and in multi-storey buildings.
Reaction to Fire BS476 Standard
Class 0
Reaction to Fire Euro Class
Class A1
Fire Resistance Minutes
Up to 120 minutes (2 hours) for load-bearing, and up to 240 minutes (4 hours) for non-load-bearing 100mm structural wall systems.
IKO Hyload Original Damp-proof Course system is a flexible polymeric sheet material, used within masonry walls to prevent passage of moisture from the ground and at all levels as cavity tray to prevent the downward movement of water.Trusted for over 40 years, Hyload Original is the UK’s leading High Performance DPC
Sovereign CDM3 Lath/Mesh Membrane provides a robust drainage membrane suitable for use above and below ground on walls, floors and arched/vaulted ceilings, as part of the SovDrain waterproofing system. This membrane has a low stud profile (3mm), thus minimising wall and floor level changes.
Sovereign CDM8 membrane provides a robust drainage membrane suitable for above and below ground applications to walls and floors as part of the SovDrain waterproofing system. With a fast track application, the membrane protects new finishes from the effects of dampness and/or salt contamination in above ground situations, and prevents water ingress below ground in areas such as cellars, basements, vaults, and tunnels. This membrane has a relatively low stud profile (8mm), thus minimising wall and floor level changes. The CDM8 membrane is typically finished with either a pre-treated timber stud partition wall and plasterboard or independent stud metal frame system. The floors can be finished with a Sovereign SBR modified screed (minimum 65mm) or a floating floor.
H+H's Celcon Blocks High Strength Grade (7.3N/mm2 identified with a black stripe on the block) is ideal where higher compressive strengths are required such as in the foundations and lower storeys of three storey buildings, piers under high vertical loads and in multi-storey buildings.
IKO Hyload Original Damp-proof Course system is a flexible polymeric sheet material, used within masonry walls to prevent passage of moisture from the ground and at all levels as cavity tray to prevent the downward movement of water.Trusted for over 40 years, Hyload Original is the UK’s leading High Performance DPC
Sovereign CDM3 Lath/Mesh Membrane provides a robust drainage membrane suitable for use above and below ground on walls, floors and arched/vaulted ceilings, as part of the SovDrain waterproofing system. This membrane has a low stud profile (3mm), thus minimising wall and floor level changes.