If fitted in a confined space, sufficient ventilation must be available to keep the valve within its ambient temperature range and access must be provided to remove the powerhead if necessary
Control by a line voltage SPST controller
Powerhead replaceable without draining down
Spring return action
Manual lever for filling and draining down
1m flying lead, head resistant cable requiring a 230V AC power supply
Quiet operation with minimal power consumption
Ambient temperature range from 5 to 50°C
Maximum close off differential pressure is 0.55 bar
The Automatic Air Vent EA122 is suitable for heating systems and other closed circuit hot water systems (not potable water) which require the efficient, automatic removal of air when a system is filling with water.
High quality lever ball valve with a blue handle to indicate cold water supply, COMPRESSION ends manufactured to BS EN 1252-3 and WRAS apoved. Lever ball valves enables an easy adjustment of the water flow where being parallel to the pipe will allows a full flow through the valve, adjusting to be perpendicular to the pipe will block the flow of water. Moving the lever between 0 and 90 degrees controls the flow. (Avaliable in red, blue and yellow).
High quality isolating valve is WRAS approved and leak tested. The valve can be opened and closed using a screwdriver to cut off the water supply so that essential repairs can be carried out.
The Automatic Air Vent EA122 is suitable for heating systems and other closed circuit hot water systems (not potable water) which require the efficient, automatic removal of air when a system is filling with water.
High quality lever ball valve with a blue handle to indicate cold water supply, COMPRESSION ends manufactured to BS EN 1252-3 and WRAS apoved. Lever ball valves enables an easy adjustment of the water flow where being parallel to the pipe will allows a full flow through the valve, adjusting to be perpendicular to the pipe will block the flow of water. Moving the lever between 0 and 90 degrees controls the flow. (Avaliable in red, blue and yellow).
High quality isolating valve is WRAS approved and leak tested. The valve can be opened and closed using a screwdriver to cut off the water supply so that essential repairs can be carried out.